Posts Tagged pressure transmitter

Using a wireless radio battery to power a pressure transmitter

In an ideal world, every place you need to install a transmitter would have easy access to electrical power. But we don’t live in the ideal world, and there are locations where power isn’t readily available, and getting electrical power to those areas can be quite costly.

This was the situation at a local plant, in their flammable fuel storage facility. The site is required to keep a record of the line pressure that supplies water in the event of a fire.

The Problem

The water pipe is located 6 to 7 feet (2 meters) below grade, and the engineers planned to build a vault where they could install and maintain the necessary submersible pressure transmitter.

The planned location is more than 500 yards from any available power source. The signal coming from the pressure transmitter would have to run that distance plus an additional 200 yards to reach the control room.

Not surprising, the trenching cost for an electrical installation was quoted at a five-figure minimum price.

Finding a solution

The project engineer started considering a wireless solution, and then asked, “Can a battery-powered industrial radio also power a two-wire loop-powered pressure transmitter?”

Read the rest of this entry »

, , , , , , , , , , , , , , , , , ,

Leave a comment

How do I set upper range value and lower range value on a Siemens pressure transmitter?

A customer needed to re-range a Siemens SITRANS P DS III transmitter without applying pressure. He’d read my earlier blog post about using the pushbuttons to program the DS III (Pressure Transmitter Pushbuttons to the Rescue!), and where to find the Z-fold instruction sheet.

All was going to plan, until he started looking for the settings for lower range value (LRV) and upper range value (URV). And then, in an all-too-familiar scenario, he hit a roadblock. The instructions don’t actually mention URV and LRV, the terms he’s familiar with, by name or acronym. So what’s a guy to do?

Read the rest of this entry »

, , , , , , , , , , , , , , , , , , , , , , ,

1 Comment

Pressure transmitter pushbuttons to the rescue!

I took a call the other day from a contractor. He was at the construction site, on deadline, and frantic. He was trying to set the zero and range on a Siemens SITRANS P DS-III pressure transmitter‘s 4-20 mA output. He had a HART handheld communicator, but no device descriptor file (DD) that made the two talk to each other. 

Could I help?  Sure! I just asked, “Do you have a Phillips screwdriver?”

Read the rest of this entry »

, , , , , , , , , , , , , ,

Leave a comment

%d bloggers like this: